Hi, I'm a newbie to OpenFoam and I was trying to do the tutorials, I've been doing great but then I got to the motorbike one and tried to run in parallel the meshing and simulation but didn't work.

As you can see I set my meshing for parallel and gives me errors no matter if I use mpirun or mpiexec (I used both of them because I saw in other forums one of those should work), however if I...

Aeroacoustic Analysis of Axial Fans 🔊🌀

Using cutting-edge CFD and CAA techniques, we conducted a comprehensive analysis of an axial fan's acoustic performance! 🔍🔊

Key insights:

Evaluated sound pressure level (SPL), power spectral density (PSD), and directional characteristics 🔊📊

Reconstructed acoustic signals from simulation results 🎧

Visual...

Hello sir

i had gone through your webinars and various papers. recently i had read your published information regarding <TCAE-CFDSUPPORT-ACOUSTIC-BENCHMARK-PROPELLER-DJI9450> . I want to try simulation on same propeller can you please provide me cad model for dji9450 propeller that you had used in Ur simulation.

 THANK YOU

What is your recommended tool flow from Solidworks to TCAE that preserves surface names (inlet, outlet, walls etc) ?

My understanding is that unfortunately Solidworks does not preserve surface names when exporting the model as...

Hello CFDSupport Team,

I am experiancing a slight problem in Paraview during simulation. Window where residuals shall be seen is a bit strange. Is this some kind of a driver problem? Do you might give me any hint where to look?

Airfoil Acoustic Benchmark NACA 0012

We are thrilled to announce the launch of our newest engineering simulation benchmark Airfoil Acoustic Benchmark NACA 0012, showcasing the capabilities of our cutting-edge simulation software, TCAE. This benchmark, centered around the NACA 0012 airfoil, delves into the realm of Computational Aero-Acoustics (CAA) and highlights t...

Hi everyone

• 1
• 0

• 1350 Views
• 1 Comments