Ifeanyi Izuegbunam

• Post By Ifeanyi Izuegbunam
• 2 weeks ago
• Post Type Public

Hi Foamers, 

Based on the given instructions underneath, I have been able to come up with this design. Could you help confirm if the attached image to this topic looks promising or requires some modifications? Thanks 😊 

“Introduction

Finishing a small meshing task is the first possibility multi-block mesh using the blockMesh utility or Salome,

e. The task, creation of a small

Geometry

wall

outlet

cut

inlet

Z

Parameters d=50.8 mm

I=508 mm a=12.7 mm

= a/2

Description

The geometry represents half of the 2" pipe inner volume. It is composed of four building blocks. The first block (No. 1) represents the core of the pipe. The other blocks (No. 2, 3, and 4) fill the outside pipe volume.

The mesh blocks must be split by more than one cell in every direction. You can select how many cells you want to use. Apply the mesh grading, if possible.

The outside volume surfaces are called inlet, outlet, wall, and cut. Select an appropriate patch type for each surface.

The blockMesh utility writes out a log. Ensure no errors are reported.

Hint: The local coordinate system in each block should be aligned with the global coordinate system!”